Falls from vehicles and trailers: avoid, prevent, then minimise

Part of our workplace transport guide: step 3 of 7

Download the trailer and flatbed falls check (Word) (DOCX · 38 KB) · Download the trailer and flatbed falls check (PDF) (PDF · 26 KB)

Why do falls from vehicles matter?

HSG136: "Loading and unloading are among the most hazardous transport activities in the workplace. People can be hit by objects falling from vehicles, struck by lift trucks, or fall from vehicles."

People fall when they slip on a load or a wet bed, trip over ropes or torn sheets, step backwards near an open edge, climb down without handholds, or work in poor light or bad weather. The height may not be large, but the landing is concrete.

What does the law say?

The Work at Height Regulations 2005 apply to any work where someone could fall and be hurt. HSE's brief guide (INDG401) defines it: "Work at height means work in any place where, if there were no precautions in place, a person could fall a distance liable to cause personal injury." There is no minimum height.

Regulation 6 sets the order:

HSG136 applies it to vehicles: "Employers must take suitable and effective measures to prevent anyone from falling a distance that is likely to result in injury. This includes getting on and off a vehicle trailer or climbing into and out of a vehicle cab." (paragraph 173)

Step 1: avoid going up

HSG136: "Avoid work at height where it is reasonably practicable to do so." INDG401: "do as much work as possible from the ground;".

Step 2: prevent a fall

If someone has to go up, protect everyone, not only the individual. HSG136: "If work at height cannot be avoided, collective control measures should always take priority over personal control measures." INDG401 says the same: "Always consider measures that protect everyone who is at risk (collective protection) before measures that protect only the individual (personal protection)."

Step 3: minimise the consequences

Only where you can't avoid or prevent a fall: work restraint that stops someone reaching an edge, or a fall arrest system. These come last because they depend on each person using them correctly every time, and a fall arrest system still means a fall. If you use one, plan the rescue. INDG401: "Don’t just rely entirely on the emergency services for rescue in your plan."

On the load and at the edge

HSG136 gives rules for anyone who does have to be on a vehicle:

And one that applies everywhere: "People should never be lifted on the forks or on a pallet, or similar, balanced on the forks of a lift truck because they can easily fall off."

Getting on and off, light and weather

Climbing into a cab or onto a trailer is covered by the same duty. Provide steps and handholds, keep them clean and in good repair, and light the places where people climb up and down. INDG401 also asks you to "take account of weather conditions that could compromise worker safety;". Rain, ice and wind change how safe a load bed is.

Visiting drivers

Drivers who deliver to many sites face the problem HSE describes: drivers of flatbed vehicles may have to climb onto the load bed repeatedly, at sites that have no gantries or similar controls (HSG136, paragraph 150). Your site is the one you control, so the platform should be at your bay.

HSG136 is also clear about sheeting: "If there are no fall-prevention measures in place at the site, drivers should refuse to sheet or unsheet the vehicle. This decision should be supported by their employer." Put your rule in the site rules and on the driver arrival card: where drivers may and may not climb, and where the platform is.

A worked example (invented)

This example is invented to show the method. It is not a real site.

A builders' merchant loads flatbeds with timber and blocks. Drivers have been climbing onto the bed to strap loads.

Task Avoid? Prevent? Minimise? Decision
Strapping Yes: strap from the ground with a strap-throwing aid n/a n/a No one on the bed to strap
Checking a load from above Partly: most checks from the ground Gantry with guard rails at bay 1 n/a Top checks only at bay 1
Sheeting Ask regular hauliers to use curtain-siders or automated sheets Gantry at bay 1 for the rest n/a Drivers told on the arrival card
Getting into the cab n/a Steps and handholds checked on arrival n/a Added to the gatehouse check

Real case

In July 2026, a chemical logistics company in Middlesbrough was fined £425,000 after a warehouse supervisor, 60, fell about 1.5 metres from a mobile loading ramp onto concrete while bales were loaded into a shipping container by forklift. He died later in hospital. The ramp had no handrail, although the manufacturer's instructions required one. HSE's press release says the company had not considered alternatives that would avoid work at height, such as using existing loading bays or putting containers on the ground. (HSE press release) That is step 1 of the order: could it have been done without going up at all?

Use this: a trailer and flatbed falls check

Download the falls check (Word) · PDF. Free, no sign-up.

One row per task that takes someone onto a vehicle (sheeting, strapping, moving cages, checking loads, cab access), with columns for avoid, prevent and minimise, lighting and weather, and your rule for visiting drivers.

Common questions

Do the Work at Height Regulations apply to lorry drivers?

Yes. They apply to any work where someone could fall a distance liable to cause injury, including climbing onto a trailer or load bed. HSE's guidance says the duty includes getting on and off a vehicle trailer and climbing into and out of a cab.

Is standing on a trailer work at height?

Yes. Standing on a trailer bed or a load is work at height, because a person could fall and be hurt if there were no precautions.

What height do you need fall protection on a lorry?

There is no minimum height in the Work at Height Regulations. The duty applies wherever a fall could cause injury. Follow the order: avoid going up, prevent a fall with collective measures, and only then use personal protection.

Who is responsible when a visiting driver falls from their trailer at our site?

Both employers can have duties. The haulier is responsible for its driver as their employer. Your site also has a duty, under the Health and Safety at Work etc. Act 1974, to people who aren't your employees but are affected by how you run your site. Agree arrangements with hauliers, and provide platforms where people need to go up.

What is the safest way to sheet a lorry?

Without anyone going up. HSE's guidance puts automated or mechanical sheeting systems, which don't need people on the vehicle, first. Where someone must go up, use a gantry or platform with guard rails. HSE says drivers should refuse to sheet where there are no fall-prevention measures, and their employer should support them.

Sources

How many times a day does someone climb onto a vehicle at your site? Safety Mapping: a free two-week trial on one camera.

Last reviewed November 2026

All guides